Changeover Of Display Screen (Fx-Pcs-Du/Win-E); Outline Of Changeover Of Display Screen - Mitsubishi F940GOT-SWD-E Operation Manual

Graphic Operation Terminal F940GOT
11.

Changeover of Display Screen (FX-PCS-DU/WIN-E)

The previous Section 10 describes creation of one screen.
Section 11 describes how to change over two or more screens.
Screen changeover can be arbitrarily specified using operation keys in the GOT or from the
PLC.
11.1

Outline of changeover of display screen

In the F940GOT, up to 500 screens can be created. A number from 0 to 499 is assigned to
each screen to control each screen.
A screen to be displayed next after the currently displayed screen should be specified using
operation keys in the GOT or from the PLC.
Not only user screens (No. 0 to 499) but also system screens (No. 1001 to 1030) in the alarm
mode or the other mode can be displayed. (Refer to Paragraph 11.6.)
n n n n Important point
1) Creation of the user screen No. 0
In the screen mode in which user screens are displayed, the screen No. 0 is always dis-
played immediately after the power is turned on.
Accordingly, the screen No. 0 should be created. If the screen No. 0 is not registered, the
error message "DISPLAY SCREEN IS NOT AVAILABLE." is displayed.
2) Screen Nos. may not be consecutive.
The screen Nos. may not be consecutive in such a way as "0, 1, 2, 3 . . ."
When there is a possibility that some screens may be inserted in the future, inconsecutive
screen Nos. can be used.
However, it is recommended to use consecutive screen Nos. because mistakes may be
reduced in screen changeover when screen Nos. are consecutive.
Changeover of Display Screen (FX-PCS-DU/WIN-E) 11
Screen changeover
specified from GOT
(operation key) or PLC
11-1