Send Data Bank (Recipe Function) - Mitsubishi F940GOT-SWD-E Operation Manual

Graphic Operation Terminal F940GOT
10.5.3

Send Data Bank (recipe function)

The GOT can store up to 4,000 16-bit data corresponding to data registers in the PLC. By giv-
ing a command through a touch key, the data can be read from/written to the PLC. For data
files, refer to "10.6 Data file".
u u u u Contents of setting
Attribute
Control Input
Bank No.
Function
1) Bank No.
Enter a file No created using the screen creation software (when selecting "Direct").
Or file No. can be specified using a control device "D0+6" (when selecting "Indirect").
2) Function
Specify the data file transfer direction.
DU à PLC: Writes data stored in a data file in the GOT to a data register in the PLC.
PLC à DU: Writes data stored in a data register in the PLC to a data file in the GOT.
n n n n Important point
• Data file transfer condition
" " indicates that transfer is enabled.
PLC
PLC memory type
PLC operation status
GOT memory type
PLC entry code
Enter a key which actuates data transfer.
Enter a data file No. to be transferred.
Select "Direct" or "Indirect".
Select "DU à PLC" or "PLC à DU".
FX Series
:RAM
:EEPROM
*1 When the read/write destination
is a data register, data can be
transferred without regard to the
memory type.
:RUN
:Flush memory
:While entry
code is regis-
tered (while
write is inhib-
ited)
Creation of Display Screens (FX-PCS-DU/WIN-E) 10
Contents of setting
:EPROM *1 :RAM
:STOP :RUN
:Flush memory
:While entry :While entry
code is code is regis-
unlocked or is tered (while
not registered write is inhib-
ited)
A Series
:EPROM
:STOP
:While entry
code is
unlocked or is
not registered
10-47