Mitsubishi F940GOT-SWD-E Operation Manual page 19

Graphic Operation Terminal F940GOT
Mode Function
Program
(list)
Parameter
BFM
monitor
Device
monitor
HPP
mode
Current
value/
set value
change
Forced
ON/OFF
State
monitor
PLC diag-
nosis
Outline of function
§Programs can be read/written/monitored in the
instruction list program format.
§Parameters for the program capacity, the mem-
ory latch range, etc. can be read/written.
§Buffer memories (BFMs) in special blocks for the
FX /FX Series can be monitored, and their
2N 2NC
set values can be changed.
§The ON/OFF status of bit devices as well as cur-
rent values and set values of word devices can
be monitored using device Nos. and comment
expression.
§Current values and set values of word devices
can be changed using device Nos. and comment
expression.
§Bit devices (X, Y, M, S, T and C) in the PLC can
be forcedly set to ON or OFF.
§State (S) Nos. in the ON status are automatically
displayed for monitoring (valid only when the
MELSEC FX Series is connected).
§The error information in the PLC can be read and
displayed.
Introduction 1
Reference
Remarks
sections
Valid in FX
Series
Valid in FX
Series
Valid in
FX /
2N
FX
2NC
Series
Note 1
4
Valid in FX
Series
Valid in FX
Series
1-5