Setting The Offset Angle - GRAPHTEC CE-3000-120 AP User Manual

Function Settings and Operations

4.22 Setting the OFFSET ANGLE

This function sets the reference value used to adjust the cutter-blade offset angle to correspond to the
displacement of the traveling angle as defined by the coordinate movement data received. The cutter blade
is controlled above the angle specified. Setting a high value will reduce the total cutting time, but the corners
of drawings cut will become rounded and may not be cut precisely. The initial setting is "30."
C L E A R B U F F E R
F E E D & C U T
B L A D E W A R E S E T U P
P E N U P / D O W N
C U T L I N E P A T .
T A N G E N T I A L
I N I T . B
P E N U P S P E E D
I N I T I A L F E E D
A U T O P R E F E E D
A D V A N C E D F U N C .
S E T U P M E N U
T E S T
4-26
(1) Press the (PAUSE) key to switch to PAUSE mode.
(2) Press the (NEXT) or
A D V A N C E D F U N C .
(3) Press the (ENTER) key, and then press the
until the following menu is displayed.
O F F S E T A N G L E
(4) Press the (ENTER) keyto display the offset-angle setting menu.
O F F S E T A N G L E
Use the or
"60," and then press the
press the (NEXT) or
(5) Press the (PAUSE) key to cancel PAUSE mode.
CHECKPOINT
This setting is retained in the internal memory even when the power is turned off.
(PREV.) key until the following menu is displayed.
3 0
key to select the required value within the range of "0" to
(ENTER) key to confirm. To cancel the selection,
(PREV.) key.
(NEXT) or
(PREV.) key