Connect Power; Connect The Cinema Projector To An It Power Distribution System - Christie CP2210 User Manual

Section 2: Installation and Setup
5. Use the security key to open the lamp door and access the lamp cooling compartment. Do not place heavy
objects on the open lamp door.
6. Turn the 2 thumbscrews on the internal lamp door counterclockwise.
7. Install the lamp. See

2.11 Connect Power

In countries such as Norway, a dedicated, protected earth wire must be installed on the cinema projector before
it can be connected to an IT power distribution system. You must use a 20A branch circuit breaker for Input A.
See Connect the Cinema Projector to an IT Power Distribution
Do not operate the cinema projector if the AC power supply and power cord are not within the specified
voltage and power range. Only use the power cord supplied with the cinema projector.
Connect one end of the cinema projector power cord to the AC receptacle on the lower-left rear corner of the
cinema projector and then connect the other end of the power cord to an AC receptacle.
If you are using an Uninterrupted Power Supply (UPS) to power the main electronics, move the AC switch to
A + B and connect the power cord provided with the UPS to the B outlet.

2.11.1 Connect the Cinema Projector to an IT Power Distribution System

In countries such as Norway, a dedicated, protected earth wire must be installed on the cinema projector before
it can be connected to an IT power distribution system. You must use a 20A branch circuit breaker for Input A.
WARNING
technician or an electrician. The protected earth wire must be green/yellow 12 AWG
minimum. See
1. If the cinema projector is operating, turn it off and disconnect it from AC power.
2-8
7.8 Replace the Lamp
Lamp
1.4kW
1.8kW
2.0kW
The dedicated earth wire can only be installed by a Christie accredited service
Projector Specifications
for lamp installation instructions.
Type
CXL-14M
CDXL-18SD
CDXL-20SD
System.
for power requirements.
CP2210 User Manual
020-100410-08 Rev. 1 (05-2014)