Communicate With The Projector; Connect To The Projector Rs232 In Port; Rs232 Communication Parameters; Message Format - Christie G Series Application Manual

Communicate with the
Projector
This section provides information and procedures for communicating with the projector from a
remote location. You can communicate with the projector through the RS232 IN port or the
Ethernet port.
When connecting the projector to a computer, use a direct connection. Docking ports can cause
software upgrade failures.

Connect to the Projector RS232 IN Port

1. Connect one end of a null standard 9-pin female to female modem cable to the projector RS232
IN port.
2. Connect the other end of the null standard 9-pin female to female modem cable to a computer.
3. Connect PIN 2 to PIN 3, PIN 3 to PIN 2 and PIN 5 to PIN 5.

RS232 Communication Parameters

This table lists the communication parameters for the projector RS232 IN port.
Parameter
Default Baud Rate
Parity
Data Bits
Stop Bits
Flow Control

Message Format

You can add a space between the code and the number when entering commands. For example,
PXT50 can be entered as PXT 50. To increase or decrease a value in some commands, enter n for
the next value and p for the previous value. For example:
(OVS0): OFF
(OVS1): ZOOM
(OVS2): CROP
If the current over scan (OVS) setting is off (OVS n) the command OVS p sets the value to zoom.
G Series Serial Commands Application Guide
020-000578-02 Rev. 1 (01-2014)
Value
115200
None
8
1
None
2