Network Control Operation; Preparing The Computer; Operating The Projector With The Computer - Christie APS Series User Manual

Network control operation

This function is designed to achieve remote control by computers connected to the same LAN.

Preparing the computer

Check all parts for damage and make preparations.
1. Make sure you have the required equipment: projector, computer, network cable connection.
2. Connect the projector to a router or switch in the LAN with a normal or jumper network cable.
In case a normal network cable fails to connect successfully, use a jumper cable instead.
3. Turn on the computer.
The LAN port on computer and projector flash after the projector is powered on.

Operating the projector with the computer

To ensure the correct use of the network control function, follow the steps below.
• If using the wireless LAN connection, check the SSID/ESSID and wireless IP address in the
network setting status and record the information.
1. Power on the projector.
2. Acquire the IP address, set DHCP to On and Automatically obtain the IP address.
You can set DHCP to Off and set up IP address manually if familiar with networking.
3. Enter the network setup menu：
a. To select network icon, select MENU on the remote controller or on the top of the control
panel, select ▲▼.
APS Series User Manual
020-002086-01 Rev. 1 (05-2023)
Copyright 2023 Christie Digital Systems USA, Inc. All rights reserved.
©
If printed, please recycle this document after use.
64