Adjustment Of The Alignment Plate Position - Konica Minolta bizhub C353 Service Manual

Field Service Ver. 2.0 Jan. 2008
7.1.3

Adjustment of the alignment plate position

• Alignment plate should be adjusted when there is a faulty alignment, the staple position
deviates.
A. Alignment procedure
NOTE
• If a step or steps are wrongly performed in mid procedure, stop the procedure
immediately. Then turn OFF the main power switch of the main body, wait for 10
sec. or more, and turn ON the main power switch. After performing these steps,
start the procedure over.
1. Turn main power switch OFF, and remove the finisher from the machine.
2. Remove the rear cover from the finisher.
See P.8
ON
1 2 3 4
4. With the rear cover of the finisher removed, install the finisher to the machine, and turn
main power switch ON.
<A4>
ON
1 2 3 4
<Letter>
ON
1 2 3 4
5 6 7 8
4583F3C514DA
5 6 7 8
5 6 7 8
4583F3C515DA
3. Check to make sure that all SW1 on
the finisher controller board are set
to OFF.
NOTE
• When not all of them are OFF, write
down the switch status and turn
them OFF.
5. When the initial operation of the fin-
isher is complete, turn on the follow-
ing switches of SW1.
When adjusting with A4: 3, 5
When adjusting with Letter: 3, 6
7. Board switch
55