Adjustment Of The Alignment Plate Position - Konica Minolta bizhub C250 Service Manual

Field Service Ver. 1.0 Jul. 2005
6.1.3

Adjustment of the Alignment Plate position

• Alignment plate should be adjusted when there is a faulty alignment, the staple position
deviates.
A. Alignment procedure
NOTE
• If a step or steps are wrongly performed in mid procedure, stop the procedure
immediately. Then turn OFF the Main Power Switch of the main unit, wait for 10
sec. or more, and turn ON the Main Power Switch. After performing these steps,
start the procedure over.
ON
1 2 3 4
<A4>
ON
1 2 3 4
<Letter>
ON
1 2 3 4
5 6 7 8
4583F3C514DA
5 6 7 8
5 6 7 8
4583F3C515DA
1. Turn main power switch OFF, and
remove the Finisher from the
machine.
2. Remove the rear cover form the Fin-
isher.
See P.7
3. Check to make sure that all SW1 on
the Finisher Controller Board are set
to OFF.
NOTE
• When not all of them are OFF, write
down the switch status and turn
them OFF.
4. With the rear cover of the Finisher
removed, install the Finisher to the
machine, and turn main power
switch ON.
5. When the initial operation of the Fin-
isher is complete, turn on the follow-
ing switches of SW1.
When adjusting with A4: 3, 5
When adjusting with Letter: 3, 6
6. Board switch
43