Factory Five Racing Mk3 Roadster Assembly Manual page 97

7. The dash harness can then be run on top of the 2"x 2" square tube over to the computer side. Run
everything loosely so that final positioning can be done.
8. The starter wires can be hooked up now. There are two different starters that were used and the wires
are run differently for each.
• On the older starters the cable runs from the starter to the empty post on the solenoid.
• On the newer starters the heavy starter wire connects to the same terminal as the body and the
smaller 8-10 gauge wire runs to the empty terminal. The newer starters can be recognized by their
smaller size and solenoid mounted on top.
(+) Battery cable
Yellow wire
Green wire
Orange/Dark Blue wire
9. When the wire harness is installed, mount the fuse panel (Use the diagram in Appendix A to
determine the correct shape) to the 2"x 2" dash hoop support and between the two ¾" x ¾" frame
tubes in the driver's side footbox using the aluminum bracket provided and a few of the self-tapping
screws.
Dash harness going through laser cut hole
Starter Solenoid Wiring
97
www.factoryfive.com 508-291-3443
.
Red/blue wire
Black cable to Starter