Factory Five Racing Mk3 Roadster Assembly Manual page 85

13. Push the ball stud retainer onto the ball on the bottom of the throttle body.
14. Push/pull the cable into the retainer so that the cable is tight.
15. Tighten the set screw in the retainer using a
16. Check the idle screw underneath the throttle body to see if the throttle arm is hitting it. If it is not,
either loosen the ball stud retainer set screw and readjust the cable or, bend the small tab behind the
accelerator pedal until the idle screw hits the throttle arm. You will notice a fairly high idle later
when the car starts if the throttle is held open.
17. After driving the car for the first time you may want to adjust the pedal locations for optimum heal/toe
and shoe size differences.
Accelerator cable attached to engine.
/ " hex key.
5
64
85
www.factoryfive.com 508-291-3443