Front Body Mounts; Front Quick Jack Bumpers - Factory Five Racing Mk3 Roadster Assembly Manual

TOOLS: / " drill bit,
5
16
PARTS: Secondary body fasteners (FFR# 10788).
1. Drill the holes at the points marked on the side of the body.
2. Push the U-nuts onto the side body mount plates.
3. Install the stainless side bolts (FFR# 10839) with a washer (FFR# 10981) next to the head and as few
washers between the body and the frame as possible so that the body clears the frame. Use a
key. Do not torque the Stainless bolts. Snug is good.
TOOLS: / " hex key, ½"combination wrench, tape measure.
3
16
PARTS: Secondary body fasteners (FFR# 10788).
1. Center the body over the frame using a tape measure to measure from the lip of the body to the rear
mounting plate of the front coil-over bracket. Check the line up with the front "X" member so that
the tape measure is parallel. Make this measurement on each side of the body so that the front of the
body is centered over the frame. Move the front of the body as necessary. If the body will not stay
where you put it, put a screw through the lip of the body into the ¾" tube.
2. Install the front mount bolts from the outside in, with washers next to the heads. Use a
and a ½" wrench or deep socket. Do not torque the Stainless bolts. Snug is good.
3. The hood opening is attached to the ¾" frame rails using countersunk sheet metal screws. Use six
screws on each side equally spaced along the length of the opening.
TOOLS: 9 / " and ⅝"combination wrenches, ⅝" socket.
16
PARTS: Quick jack bumper components (FFR# 10553)
1. File the inside of the quick jack hole if necessary so that the spacers do not touch the body.
2. Tighten the bolts with a ⅝" socket and ⅝" wrench.
/ " hex key, drill, ½" wrench.
3
16

Front Body Mounts

Front body mounts as assembled by the factory

Front Quick Jack Bumpers

www.factoryfive.com
127
508-291-3443
.
/
3
16
/ " hex
3
16
" hex key