Table of Contents
Advertisement
3. From the passenger outer corner, go towards the first 2"x 2" frame outrigger alongside the 4" round
tube.
4. Fasten the lines to the 2"x 2" square cockpit outriggers with the insulated line clips.
5. In a similar fashion to the rear brake line, run the fuel lines up the back of the 2"x 3" frame member to
the fuel filter for the
6. Continue the ¼" line to the end of the 2"x 3" frame member then go down and make another bend so
that the line will clear under the ¾" tubing that forms the lower trunk section.
7. Bend the line so that it will cross to the fuel return connector (the smaller tube) on the gas tank.
8. Cut the line four inches from the connector.
9. Do the first part of a double flare on the ends of the fuel lines. This helps prevent the hoses from
coming off.
10. Use the ¼" flexible line (FFR# 10997),
(FFR# 10855) to connect the Mustang connectors to the hard line.
Fuel line routing in front of the passenger foot box
/
" line. Cut the
/
" line three to four inches from the fuel filter.
5
5
16
16
Fuel Line flared.
/
" flexible line (FFR# 11051), and fuel injection hose clamps
5
16
www.factoryfive.com
74
508-291-3443
.
Advertisement
Table of Contents
