Table of Contents
Advertisement
1. Using the Thunderbird flexible brake line with the "T" connection on it, hold it up to the ¾" tubing on
the driver's side that connects the two 2"x3" frame rails. Mark the location of the mount hole and the
locating pin hole on the tube as shown in the picture.
2. Drill two
/
" holes, one for the mount screw and one for the locating pin.
3
16
3. Mount the "T" junction to the tubing.
4. If using the Completion Package the brake line mount will attach to the frame in this location and
support the "T" adapter.
5. Mount the other flexible line to the passenger side of the frame in the same location.
6. Insert two of the brake fitting adapters into the "T" and tighten with a ½" wrench. These are not used
with the completion Package.
Driver side brake line mount
Passenger side brake line mount
252
www.factoryfive.com
508-291-3443
Advertisement
Table of Contents
