Factory Five Racing Mk3 Roadster Assembly Manual page 244

15. Bolt the Panhard bar frame mount to the back of the frame using the supplied ½"x 2.5" bolt and
locknut.
16. To set the alignment, make sure that your ride height is where you want it, then adjust the pinion
angle. We usually run about 2˚ up on the rear axle, but you can adjust this to fit your particular set-
up.
17. The Panhard bar can also be set left to right, as well as leveled.
18. Double check all your nuts and bolts, and make sure that all four jam nuts are tight.
TESTING AND TUNING
The three link will make a dramatic difference in the way your car handles, most noticeably the lower roll
center in the rear will produce much more body roll in corners. In order to fully optimize the new
suspension we recommend using the rear coil-over shocks and springs with the set-up.
Drill through mount into back of frame
244
www.factoryfive.com 508-291-3443