Table of Contents
Advertisement
5. From the battery forward, use some of the black plastic wire loom (included with kit) to cover and
protect the rear harness and the battery cable.
6. Replace the cable ties that were used earlier during the battery cable install with the large insulated
line clips where possible.
7. Run the harness forward with the battery cable (zip tie them together to prevent movement) to the
beginning of the driver foot box, passing over the transmission harness section on the way.
8. Place insulation grommeting around the ¾" hole in the upper corner of the inside driver foot box.
9. Slide the harness down the edge of foot box into hole.
10. Cable ties can be used to secure the harness up to the hole by drilling two
and passing a zip tie through it.
11. At the front of the tunnel, the rear harness goes up into the top foot box area where it meets the
dash/engine main harness.
12. Wrap the extra harness around the ¾" tubing in the foot box and zip tie it in place.
Rear trunk wiring harness attached along frame
Transmission Harness
Transmission harness
94
www.factoryfive.com
508-291-3443
.
/
" holes about a ¼" apart
3
16
Advertisement
Table of Contents
