Factory Five Racing Mk3 Roadster Assembly Manual page 44

5. Holding the dust boot in place, insert the ball joint into the Spindle Adapter bracket (FFR# 13819).
This bracket replaces the Mustang strut. Be sure to use the cotter pins included with the ball joint.
Torque the ball joint to 95-122Nm (70-90 lbft). If the top of the crown nut goes past the hole in the
ball joint, use the spacer that comes with the ball joint.
6. Attach the Spindle adapter bracket/upper A-arm assembly to the spindle using the factory strut bolts
and torque to 135-149Nm (100-110 lbft).
Note: Using the 87-93 spindles, use the hole closest to the ball joint and the third hole down. Using
a 94-04 Spindles, attach the bracket using the bottom and third hole up so that the ball joint
is further away from the spindle.
7. Install the front lower control arms on the frame using the holes towards the OUTSIDE of the frame.
Ball joint in IFS Bracket.
44
www.factoryfive.com 508-291-3443