Factory Five Racing Mk3 Roadster Assembly Manual page 67

1. Position the foot box floor. The front edge sits on top of the front wall bottom tab and the back gets
attached to the 2"x 2" tube.
10. Mark where the rivets will go.
11. Remove the panel and apply silicone to the frame.
12. Attach the panel with self-tapping screws.
13. Rivet the panel in place.
14. Position the outside wall on the foot box. The tab on the front wall goes on the inside of the outside
foot box wall.
15. Mark where the rivets will go.
16. Remove the panel and apply silicone to the frame.
17. Attach the panel with self-tapping screws.
18. Leave the top edge of the panel that rests along the ¾" tubing unattached so that the foot box top can
fit under it later.
19. Rivet the panels in place.
20. Position the inside wall on the foot box from the engine compartment side. The bent tabs go behind
the front wall.
21. Mark where the rivets will go.
22. Remove the panel and apply silicone to the frame.
23. Attach the panel with self-tapping screws.
24. Rivet the panel in place.
25. Position the top/inside panel.
26. Remove the panel and apply silicone to the inside wall, front wall and along the top ¾" frame tube.
27. Rivet the panel to the inside and front walls only.
ATTENTION: Leave the top/outside of the driver's footbox open in order to do the wiring.
Driver's footbox
67
www.factoryfive.com 508-291-3443