Factory Five Racing Mk3 Roadster Assembly Manual page 84

5. Insert the pedal end of the cable into the foot box.
6. Screw on and tighten the
7. Hold the accelerator pedal up to the mount on the ¾" tube at the front of the foot box. The higher you
can mount the pedal the better the pedal will be positioned on your foot. The key things to watch for
is clearance between the accelerator pedal and clutch quadrant stop and keeping the cable straight so it
will not rub on the side of the cable sheath. If a higher location is desired, some material can be
removed from the bottom of the clutch quadrant stop. If mounting higher, mark and drill new holes
for the bolts in the pedal.
8. Attach the accelerator pedal to the mount using the ¼"x ¾" bolts, washers and lock nuts.
9. Cut the accelerator pedal capture in the corner using a pair of wire cutters.
10. Slip the accelerator cable through the cut so that the ball will sit in the recess.
11. Push the capture into the end of the throttle pedal.
12. Attach the engine end of the cable sheath to the cable mount on the intake using ⅜" and
and push the cable wiper onto the remaining threads.
Ball stud retainer pushed onto cable.
/ " locknut on the cable sheath inside the foot box using two ½" wrenches.
5
16
84
www.factoryfive.com 508-291-3443
/ " wrenches
7
16