Table of Contents
Advertisement
14. Insert and attach the radiator floor aluminum using either the screws provided or ⅛" rivets every 2".
15. Apply silicone to the ¾" tubing where it will contact the aluminum sidepieces.
16. Install the sidepieces. The bottom goes on top of the floor aluminum. Hold the pieces in place with a
couple of #8 screws.
17. Drill and rivet them into place.
18. Drill three
3
/
" holes and rivet the nose aluminum floor to the body with
16
19. Remove the floor jack from the radiator.
20. Apply silicone where the aluminum and body meet and where the radiator and aluminum meet.
ATTENTION:
• Try not to drop the side exhaust assembly as it will probably land on the outer curved surface
and dent (if it sounds like this has happened to us, it has). If you are using our optional
headers, some of these instructions may not be necessary.
• The passenger side pipe may look crooked without the body mounted. This is normal. Once
the body is mounted it will be parallel to the body.
TOOLS: ½" and
/
" sockets, jack stands, jack, ¼",
9
16
PARTS: 4 into 4 side exhaust (FFR# 13940), straight tubes (FFR# 13891), Mustang Oxygen sensors.
1. Cut the large exhaust hanger in half lengthwise.
Drilling the radiator and aluminum nose panels
Side Exhaust
/
" hex keys,
5
16
152
www.factoryfive.com
508-291-3443
.
3
/
" rivets.
16
/
",
/
"drill bits, drill, hack saw.
5
5
16
16
Advertisement
Table of Contents
