.
Side louver cut out
Headlight Cut-Outs
TOOLS: Hand jigsaw, drill, marker, tape,
/
" drill bit.
7
16
1. Using a
/
" drill bit, drill the two holes marked at the headlight mount locations.
7
16
2. On the headlight template that follows, cut out the two small holes and the inner solid line circle.
Leave the template attached to the paper so that it has extra support.
3. Tape the template to one of the headlight locations.
4. Draw around the inner circle with a marker.
5. Drill a
7
/
" hole in the inside of the circle so that the edge of the hole is just touching the circle.
16
6. Use a jigsaw to cut the circle out.
Headlight and turn signals cut out.
119
www.factoryfive.com
508-291-3443
Need help?
Do you have a question about the Mk3 Roadster and is the answer not in the manual?