Table of Contents
Advertisement
the body/chassis.
12. All of the arms should remain attached to the rear end assembly. Once off, place the OEM bolts back
into the arms and attach nuts so they do not get lost.
13. Remove the rear end from under the car.
14. Remove the brackets that secure the quad shocks to the frame. Make sure you get the complete
bracket and not just the shock.
15. The sway bar is located under the lower control arm and remains there. It can be used on our car but
we do not recommend it. The sway bar does not improve the handling of the car.
16. Use a drill with a ¼" bit to drill out the rivets on the brake bracket, which retain it to the body above
the differential. Keep this bracket for use later.
TOOLS: Socket set, small flat head screwdriver.
PARTS: Rear fuel lines and fuel filter mount.
1. Remove the fuel filter and fuel filter mount from the frame.
2. Disconnect the rear fuel lines going from the tank to the filter and the return line to the tank from the
frame and store these parts.
1. Remove the rubber spacer from inside the coil.
2. Cut one full coil from the top of the spring for correct ride height setting.
Fuel filter and lines
Donor Part Preparation
Rear Coil Springs
Rear coil spring.
27
www.factoryfive.com
508-291-3443
Advertisement
Table of Contents
