Factory Five Racing Mk3 Roadster Assembly Manual page 71

• It is a good idea to make a small loop at the end of the lines (where they secure to the brake line
mounts or master cylinder). This loop will provide good adjustment for any small variances
without bending or crimping the line and provide protection from vibration.
TOOLS: Phillips and regular head screwdrivers, tube bender, double flaring set, tube cutter,
bit, drill, rivet tool, marker, tape measure, electrical tape.
PARTS: Insulated clip hardware (FFR# 11029), battery relocation kit (FFR# 12396), misc. electrical
components (FFR# 10975), ¼" fuel line (FFR# 10784),
and 60" / " brake lines (FFR#'s 13740, 13739, 13738).
3
16
1. Attach two 60" lines together using the union provided.
2. Run the rear brake line under the driver's side on the outside of the 4" round tube and fasten to the 2"
x 2" cockpit outriggers.
Brake line loop made using two ⅞" sockets and a vise.
Brake line loop.
Rear Brake Line
71
www.factoryfive.com
/ " fuel line (FFR# 10783), 20", 51"
5
16
508-291-3443
/ "drill
3
16