Factory Five Racing Mk3 Roadster Assembly Manual page 123

1. Position the rear L-shaped handles (part of the three lock set FFR# 10624) in the holes near the rear of
the hood. Point the handles to the rear of the hood.
2. Use a small square file to make room for the tabs on the handles.
3. Using a ⅛" drill bit, drill holes in the hood for the mounting screws. Attach the handles to the hood
using the Philips head screws.
4. Using the key for the three-lock set, lock the handles.
5. Place the hood on the car. The driver's side handle square rod is too long and hits the top of the foot
box. Mark and shorten this rod with a hacksaw until it clears the foot box.
6. The handle is locked pointing towards the back of the car. Place some masking tape on the body
behind the handles then, using a pen, mark on the body where the handle is pointing.
7. Remove the hood. Hold the angled aluminum brackets (included with kit) to the underside of the
hood lip at the locations just marked.
8. Using a pen, mark on the brackets where two screws can go.
9. Drill two ⅛" holes through the bracket.
Driver side hood handle
Hood handle hold down bracket mounted to underside of hood lip
www.factoryfive.com
.
123
508-291-3443
.