Factory Five Racing Mk3 Roadster Assembly Manual page 230

Fuel line and pressure regulator mounted at rear of engine (For carbureted applications)
3. The electric fuel pump should be mounted to a frame rail as close to the tank as is practical. The 2"x
3" is a good solid location, however, some pumps must be mounted below the pickup so a bracket
may have to be made.
III. Engine Preparation
1. The intake manifold used must have sufficient clearance for the air cleaner underneath the hood
scoop. The Edelbrock Torker II manifold will fit but it is about the maximum height useable. The
high-rise intake that comes with the 460 crate engines from Ford will not fit under the stock hood
scoop.
460 Single plane manifold with 850 CFM Carburetor
230
www.factoryfive.com 508-291-3443