Panel Setup Menu; Panel Setup Menu Overview - Oce CS9160 User Manual

4.6.2 Panel setup menu overview.

The following items are found in the Panel setup menu.
Setup item
Setup menu
Test print menu
Adjust print menu.
Cleaning menu
Selection menu
Version menu
Sleep mode menu
For details regarding the setup menu, refer to "Panel setup menu"

4.7 PANEL SETUP MENU

In the table below you will find the complete menu structure and its function:
Setup item
Set1: MediaType
Set2: Effect
Set3: Flushing
Set4: Side Margin
Set5: Media Initial
Set6: Media Width /
MediaWidth Check
Set9: Origin
Set10: Prev. Stick
Set11: HeadFan
Set12: CR Movement
Set13: Overwrite Cnt
Set14: Overwrite Wait
Set15: Slant Check
Set16: Auto Cleaning
Set17: Ink Status
Set18: Roll Length
Set19: Head Wash
Set20: CR Maintenance
Set21: Initialization
Set22: Life Times
Set23: IP Address
Set24: Subnet Mask
Set25: Gateway
Set26: Temporary
—
Various settings of the printer are configured.
Performs a nozzle check of the print head and setup list.
Print and adjust test patterns for alignment.
Perform head cleaning
set up the contents of the setup menu
Displays the version of the firmware
Sleep mode settings are configured.
Set up the media type for printing.
Set up the Effect menu.
Set up the Flushing operation while printing.
Set up the right and left margin when printing.
Set up whether the media width and edge are detected when initializing the
media.
Specifies the media width between the loading mark and the left end if media
detection is not performed during media initialization.
Displays the detected media width if media detection is performed during media
initialization.
Set the start position of the printing data.
Set up to prevent media from sticking when printing.
Set up head fan operation
Set up the distance to move the print head while printing.
Set up the Overwrite Cnt per swath.
Set up the waiting time while overwrite printing.
Set up the slanting detection between two consecutive print jobs
Set up the auto cleaning time while printing.
Display the remaining ink level of the ink cassette that was installed into the ink
cassette slot.
Set up the roll media length.
Perform a head wash
Unlocks carriage from home position in order to be able to clean the wiper.
The parameter values of the printer are restored to their factory defaults
Display the operational life time of each part.
Set the IP address of the printer.
Set the subnet mask of the printer.
Set the Gateway.
The settings of "OFF" or "ALL OFF" in the Selection menu are displayed in the
setup menu temporary.
[Cancel] key: Shift to the previous hierarchy.
User's Guide Océ CS9160 printer
Description
Description
73 AP-40790 – Rev 2.0 -23/08/2011,