Oce CS9160 User Manual page 14

•
Do not open covers attached with screws under any circumstance. This could cause an electric shock or
printer breakdown.
•
While cleaning with the wiper
o Do not touch the cleaning wiper and head cap unit.
Head cleaning may not be operated correctly because of the grease attached.
o Make sure to wipe the print head with a dry poly-knit wiper.
•
Do not make the main body of the printer slanting or place it in a vertical position or do not keep the
printer upside down. There is a possibility that ink inside the printer may leak. Moreover, normal
operation after shifting (to these positions) cannot be guaranteed.
•
Unpacking, transporting and installing the printer to the installation place must be done by 4 or more
persons
• Move the printer maintaining it in a horizontal position.
Do not make the main body of the printer slanting or place it in a vertical position, nor keep the printer
upside down. There is a possibility that the ink inside the printer may leak. Moreover, normal operation
after shifting to these positions cannot be guaranteed.
•
While taking out the printer from the container box, make sure to remove the vinyl sheet and hold the
handles on the printer side. If the printer is lifted with the vinyl sheet attached, there is a possibility that
the printer might fall and might be damaged.
•
While installing the stand, be sure to switch OFF the printer power and to pull out the power plugs. It
could lead to an electric shock.
•
If the printer is not used for a longer period, make sure to pull out the power plugs from the power
sockets for safety reasons.
• Make sure to connect an earth wire to the earth connection which meets the following standards:
Earth terminal of power socket
o
Earth wire with copper plate which is buried at 650 mm or more, deep in the ground.
o
•
Set the roll media on an even surface such as a desk etc. If the roll media is set in such a way that the
scroller is standing vertical, there is a possibility that the scroller might get damaged.
• When printing is finished, the media guide is at high temperature. Wait until the media guide cools off.
• Pay attention when you cut roll media. Mishandling the razor blade may cause a cut in your finger or
hand.
When you hold media, do not place your finger on the media cut groove.
o
Move the razor blade along the media cut groove.
o
•
Follow the instructions below when handling the power plugs. Otherwise, fire may occur.
Wipe away dust and any other residue before inserting the plugs.
o
Ensure that the plugs are firmly inserted as far as it will go.
o
•
Ensure that the plugs have been disconnected from the power sockets when they are not used for a long
time.
•
Do not drop waste fluid when replacing the spitting-box sponges. If waste fluid comes into contact with
the grid roller, the surface of the grid roller will be damaged, and the media feed function may be affected.
• When cleaning around the print head
Do not touch the nozzle of the print head; doing so may damage the print head.
o
Do not touch the head of the cleaning stick, oil on your hands may attach to the cleaning stick,
o
causing damage to the print head.
Do not immerse the head of the cleaning stick in water; doing so may damage the print head.
o
Do not reuse the cleaning stick; dust attached to the stick may damage the print head.
o
User's Guide Océ CS9160 printer
14 AP-40790 – Rev 2.0 -23/08/2011,