Handling Inks / Cleaning + Waste Of Inks / Cleaning - Oce CS9160 User Manual

1.4 HANDLING INKS / CLEANING + WASTE OF INKS /
CLEANING
Caution
•
Before handling inks/ cleaning and their waste, do carefully read the MSDS-sheet and the
container labels for important health, safety and environmental information.
•
Only use original manufacturer's ink and appropriate cleaning liquid. Before installing the ink cassette,
shake it gently. Doing so will preserve print quality.
•
When an ink cassette is moved from a cold place to warm place, keep the ink cassette for three hours or
more in the new printing environment before printing.
• Inks
o General advice: wear safety glasses and gloves especially when handling the waste ink.
o After spill: remove contaminated clothing.
o After inhalation: if difficulties occur after vapour/aerosol has been inhaled, remove to fresh air and
seek medical attention.
o After skin contact: wash thoroughly with soap and water.
o After eye contact: wash affected eyes for at least 15 minutes under running water while eyelids held
open.
o After swallowing: rinse mouth and drink plenty of water. Never induce vomiting.
•
Do not disassemble ink cassettes. Otherwise, ink may get in your eyes or on your skin. Also a
disassembled ink cassette cannot be used.
•
When refilling ink, use original manufacturer's ink cassettes. This printer is designed to use genuine ink
cassettes. If you use ink cassettes which are not produced by the original manufacturer,
printing might become blurred and the end of the ink in the cassette might not be detected correctly
o
Any problems caused by using an ink cassette other than those recommended above will not be
o
covered by the warranty, and repair expenses will be paid by the customer.
•
For handling waste : Refer to: section 13 on the MSDS-sheet
General safety instructions that must be observed to use the equipment safely are explained below.
•
Do not install the printer in places where there is a possibility that the printer may be damaged or might
fall by chance. For example:
On a shaky stand
o
Slanting location
o
Places where vibration of other machines etc. is transmitted
o
•
Do not stand on the printer or do not place heavy things on top of it. The printer may be damaged or
might fall.
•
Cover the printer with a blanket or cloth like table cloth and do not close the vent. If the vent is closed,
the printer could accumulate heat inside and may cause fire.
•
Do not install the printer in places where the humidity is high or in a dusty environment. It could lead to
an electric shock and/or fire.
•
Do not use damaged power cables. It could lead to an electric shock and / or fire.
•
Do not take out or insert the power plugs with wet hands. This could lead to an electric shock.
• Wire the various cables as explained in the User's Guide. Wrong wiring could cause fire.
• Be careful that your fingers are not caught when opening or closing the media cover or front cover.
•
Do not touch the media guide during printing. It is hot and may cause burns.
User's Guide Océ CS9160 printer
12 AP-40790 – Rev 2.0 -23/08/2011,