4.7.1 MediaType menu
Setup item
Media
4.7.1.1
User media menu
Notes
If non-compatible media is used, the following problems may occur:
Media detection error
o
Slant, snag and wrinkle of media
o
Media jams
o
Optimum printing quality cannot be obtained due to blots, blurs and dirt of ink.
o
End detection of roll media cannot be performed, etc.
o
•
The problems caused by the use of non-compatible will not be covered by the warranty and
repair expenses will be paid by the customer.
For details, contact your OCÉ local representative.
Setup item
Type 1 to 30
Setting Value
Type 1
Type 2
...
Type 29
Type 30
—
Setting Value
Print mode
PF Adjust
Pre Heater
Fixer (platen)
Dryer
StandbyHeating
Vacuum Fan
—
74
User's Guide Océ CS9160 printer
Description
Set up the media type for printing.
It is possible to set 30 different user settings as
"Type 1-30" for printing.
[Enter] key: Shift to the next hierarchy.
refer to: User media menu
[Cancel] key: Save the setting value and shift to
the previous hierarchy.
refer to Setup menu
Description
Set up the print mode according to the used print
data or print speed.
•
[Enter] key: Shift to the next hierarchy.
refer to Print mode menu
Various settings on the Media feed compensation
can be set.
•
[>] key: Shift to the next hierarchy.
refer to Dist. Adj menu
Set up the Pre Heater temperature.
•
[Enter] key: Shift to the next hierarchy.
refer to Pre heater menu
Set up the Platen Heater temperature.
•
[Enter] key: Shift to the next hierarchy.
refer to Platen heater menu
Set up the After Heater temperature.
•
[Enter] key: Shift to the next hierarchy.
refer to After heater menu
Set up whether the heater is preheated while in
standby mode.
•
[Enter] key: Shift to the next hierarchy.
refer to StandbyHeating menu
Set up the vacuum fan operation
•
[Enter] key: Shift to the next hierarchy.
refer to Vacuum fan menu
•
[Cancel] key: Shift to the previous hierarchy.
refer to Media type menu
AP-40790 – Rev 2.0 -23/08/2011,