Dryer Menu; Standby Heating Menu; Vacuum Fan Menu - Oce CS9160 User Manual

4.7.1.11 Dryer menu

Notes
•
Temperature to be set for the after Heater varies depending on the media which is used. For
recommended temperature settings of the after heater, refer to the "Recommended media list".
Setup Item
After Heater

4.7.1.12 Standby Heating menu

Set up whether each heater is preheated (idle heat) while in standby mode.
Setup Item
StandbyHeating

4.7.1.13 Vacuum Fan menu

Setup Item
Vacuum Fan
Setting Value
OFF / <30° C> to 50° C
—
Setting Value
Sets the length of time to preheat the heaters. When more than
10 min to <60
the set time has passed, each heater switches off
min> to 240 min
•
— •
Setting Value
Low Set when using soft media
<High> Set when regular media is used.
•
—
•
Set up the after Heater temperature.
2
1. Roll media
2. Dryer- After heater
3. Print head
• [Enter] key: Save the setting and shift to the
previous hierarchy.
• [Cancel] key: Cancel the setting and shift to
the previous hierarchy.
► User media menu
Description
[Enter] key: Save the setting and shift to the previous
hierarchy.
[Cancel] key: Cancel the setting and shift to the previous
hierarchy.
► User media menu
Description
[Enter] key: Save the setting and shift to the previous
hierarchy.
[Cancel] key: Cancel the setting and shift to the previous
hierarchy.
► User media menu
78
User's Guide Océ CS9160 printer
Description
3
AP-40790 – Rev 2.0 -23/08/2011,
1