Step 7 :
Perform the initial adjust print.
• Press the [Enter] key.
The operation panel displays "Feed Length: 250 mm".
o
Notes
•
The length that the media is fed for initial adjustment printing is normally set at 250 mm.
•
If you make the feeding length longer, the accuracy of the Media feed compensation improves.
If you want to change the feeding length, press the [+] key or [–] key and change the set value.
• Press the [Enter] key.
The operation panel displays "Printing".
o
Start Initial adjustment printing.
o
1
When the initial adjustment printing is complete, the printer enters the normal status
o
• After the initial adjustment printing, cut the media. Refer to: "Cutting media"
Step 8 :
Measure the distance between two "+" signs in the initial adjustment print using a measurement
tool, such as a ruler.
Step 9 :
Set up Initial Adjust Change.
• Press the [+] key or [–] key to select "PF2: Initial Change".
• Press the [Enter] key.
The operation panel displays "Init: 250.0/250mm".
o
• Press the [+] key or [–] key and enter the measured value in step 3.
• Press the [Enter] key.
The initial adjustment value is saved.
o
The operation panel displays "PF2: Initial Change".
o
N°
Name
1
Feed length
2
Media feeding direction
57
User's Guide Océ CS9160 printer
1
AP-40790 – Rev 2.0 -23/08/2011,
2