Step Adjustment - Oce CS9160 User Manual

4.3.5 Step adjustment

After every printed swath, the media is fed a certain distance. Depending on the kind of media (weight,
backing) another media feed compensation has to be set. This to avoid the following phenomenon:
•
Printed swaths overlap.
•
White lines between every swath.
In such cases, follow the procedure below and adjust the media feed compensation value.
Step 1 : Display the Media feed compensation menu.
Step 2 : Press the [Menu] key.
•
Shift to the Setup menu display.
•
The operation panel displays "Menu 1: Setup>".
Step 3 : Press the [>] key.
•
The operation panel displays "Set1: MediaType".
Step 4 : Press the [Enter] key.
•
The operation panel displays "Media: Type 1".
Step 5 : Press the [+] key or [–] key to select the media type you wish to use.
Step 6 : Press the [Enter] key.
•
The operation panel displays "**>1: Print Mode".
Notes
•
The selected media (Type 1-30) is displayed in "**". Please refer to "Media Type menu"
•
Press the [+] key or [–] key to select "**>2: PF Adjust>".
•
Press the [>] key.
The operation panel displays "PF1: Initial Print".
o
User's Guide Océ CS9160 printer
56 AP-40790 – Rev 2.0 -23/08/2011,