Oce CS9160 User Manual page 58

Step 10 : Perform the Confirm Print.
•
Press the [+] key or [–] key to select "PF3: Confirm Print".
•
Press the [Enter] key.
The operation panel displays "Feed Length: 250 mm".
Notes
•
The length that the media is fed (feeding length) for confirmation adjustment printing is
normally set at 250 mm.
•
If you make the feeding length longer, the accuracy of the Media feed compensation improves.
If you want to change the feeding length, press the [+] key or [–] key and change the set value.
•
Press the [Enter] key.
The operation panel displays "Printing".
o
Start Confirmation adjustment printing.
o
1
•
After the confirmation adjustment printing, cut the media. For more information, please refer to: "
Cutting media"
Step 11 : Measure the distance between two pluses in the confirmation adjustment print using a
measurement tool, such as a ruler, confirm that the distance matches the feeding length when
printing.
•
If the distance does not match the feeding length, follow the procedure from 1 to 5 and re-adjust.
N° Name
1 Feed length
2 Media feeding direction
58
User's Guide Océ CS9160 printer
1
AP-40790 – Rev 2.0 -23/08/2011,
2