4.4.3 Nozzle check
Used to check whether there are any head clogging, missing nozzles or misfiring nozzles.
Notes
•
If the nozzle check result indicates that the checked points are blurred or missing, clean the
head.
Refer to: Head cleaning.
Perform the nozzle check once again after the head has been cleaned.
Notes
•
For the printing procedure, refer to "Performing a test print".
4.4.4 Mode Print
Used to confirm the following printing conditions:
•
Print mode
•
Effect
•
Pre heater set temperature
•
Fixer (Platen) heater set temperature
•
Drier heater set temperature
•
Adjustment value
Notes
•
For the printing procedure, refer to "Performing a test print".
User's Guide Océ CS9160 printer
65
AP-40790 – Rev 2.0 -23/08/2011,