6.1.2 Adjust the print head
Notes
•
This printer was adjusted at factory shipment so that it obtains the optimum print quality.
•
Adjust the quality if the print quality change after the installation environment or the media is
changed.
Step 1 :
Switch ON the printer and load the roll media.
Refer to: "Setting roll media"
Step 2 :
Confirm that the printer functions normally.
Step 3 :
Display the printing mode menu.
Step 4 :
Press the [Menu] key.
•
"Menu1: Setup>" is displayed.
•
The operation panel shifts to the Setup menu display.
Step 5 :
Press the [>] key.
•
"Set1: MediaType" is displayed.
Step 6 :
Press the [ENTER] key.
•
"Media: Type1" is displayed.
Step 7 :
Press the [+] key or the [-] key to select the media type to use.
Step 8 :
Press the [ENTER] key
"**>1: print mode" is displayed.
Notes
•
The selected media is displayed in "**". For more information please contact your local Océ
representative
Step 9 :
Press the [ENTER] key.
•
"Mode: graphics 1 ->" is displayed.
•
The display shifts to the printing mode menu.
Step 10 : Select the printing mode that you want to use.
Step 11 : Press the [+] key or the [-] key to select the printing mode to use.
Step 12 : Press the [cancel] key several times.
•
The operation panel returns to Normal.
Step 13 : Display the Adjust Print menu.
Step 14 : Press the [Menu] key.
•
"Menu 1: Setup>" is displayed.
•
The operation panel shifts to the Setup men display.
Step 15 : Press the [+] key or the [-] key to select "Menu3: Adjust Print>"
User's Guide Océ CS9160 printer
117
AP-40790 – Rev 2.0 -23/08/2011,