Cleaning Around The Print Head - Oce CS9160 User Manual

5.1.2.2

Cleaning around the print head.

Be sure to read and understand the safety warnings before handling the printer.
Clean the print head when foreign objects, such as dust or ink, causing omitted dots or ink drops are
attached around the print head.
Notes
•
Before starting to clean around the print head, read and understand this procedure, then clean
promptly and accurately.
•
When cleaning around the print head, the print head cap must be removed and cleaning must
be complete before the head dries. The recommended time for cleaning is about 15 minutes.
•
If cleaning exceeds 15 minutes, discontinue it by following steps 7 and 8. Perform head
cleaning, and then start cleaning around the print head again. For more information please
refer to:" Head cleaning"
• Use the cleaning stick to clean around the print head.
Step 1 : If the printer is switched ON, make sure that.
•
Printing or other operations are not in progress.
•
The operation panel display is Normal.
Step 2 : Display the CR Maintenance menu.
Step 3 : Press the [Menu] key.
•
"Menu 1: Setup>" is displayed.
•
The operation panel shifts to the Setup menu display.
Step 4 : Press the [>] key.
•
"Set1: MediaType" is displayed.
Step 5 : Press the [+] key or the [-] key to select "Set20: CR maintenance"
Step 6 : Press the [ENTER] key.
• "CR Mainte.: Start" is displayed.
• The display enters the CR Maintenance menu.
 For more information please refer to "periodical Maintenance".
User's Guide Océ CS9160 printer
103 AP-40790 – Rev 2.0 -23/08/2011,