Oce CS9160 User Manual page 34

(3) Replacement steps
Caution
•
When handling ink cassettes, be careful not to get ink into your eyes or on your skin. However,
if this happens, flush immediately with water. Otherwise, your eyes can become slightly
inflamed. If you feel discomfort, immediately consult a doctor.
•
Do not disassemble ink cassettes. Otherwise, ink can get into your eyes or on your skin.
Notes
• Do not shake ink cassettes to avoid ink leakage.
• Do not disassemble the ink cassette. A disassembled ink cassette cannot be used.
•
When an ink cassette is moved from a cold place to a warm place, keep the ink cassette unused
for three hours or more in the printing environment.
•
Do not refill the ink cassettes to avoid incorrect printing behaviour.
•
Insert or remove the ink cassette at the time of replacement only.
Inserting or removing ink cassettes except at the time of replacement may result in incorrect
printing.
Notes
•
Do not replace ink cassettes when the printer is switched OFF to avoid incorrect detection of
the remaining ink and result in abnormal printing behaviour.
Notes
•
A used ink cassette must be put in a vinyl bag or a bag used for this kind of waste. Disposal of
an ink cassette has to be done in compliance with the regulations and instructions of the local
authorities.
Notes
• Open the ink cassette solvent resistant blister just before attaching the ink cassette into the
cassette slot. Leaving the ink cassette open for a long time can result in an abnormal printing.
• Replace the ink cassette within 6 months after installing it into the printer.
• Insert or remove the ink cassette not more than 10 times. This to prevent that the smart chip or
its reader would be worn out and malfunction in this way. If inserted or removed more than 10
times the ink cassette could malfunction even if there is some ink remaining.
Notes
•
The printer resumes printing when you have replaced (an) ink cassette (s) after an ink end
occurred during printing.
Be sure to read and understand the safety warnings before handling the printer.
Step 1 : Verify that the printer is powered ON.
Step 2 : Remove the empty ink cassette(s) from the ink cassette slot (s)
Step 3 : Unpack the new ink cassette(s).
Step 4 : Insert the new ink cassette(s)
Step 5 : Verify that the printer returns to the Normal mode
User's Guide Océ CS9160 printer
34 AP-40790 – Rev 2.0 -23/08/2011,