Table of Contents
Advertisement
4.2.12
Factory default
Restore the factory defaults as follows
4.2.13
Copies
In case multiple outputs of a specific design are needed, you can use the copies function. This function will
replot the last set of data, which was sent to the cutting plotter. That is, all data that was sent since the last
INITIALISATION command ("IN").
Copies
0 – 1 -100
Notes
When you want to make copies, make sure that the 'Sheet Off' mode is enabled. Otherwise you'll
perform a multi-cut. The cutter will cut continuously on the same place.
In case of identical frames without barcode, copying contour cutting tasks can be done via the COPY
menu option as well as from roll and sheet.
When you perform a lever up action during a job, all data will be cleared out of the buffers, which
means, no copies can be made anymore of the job.
F a c t o r y d e f a u l t
Y E S
S a v e :
F a c t o r y d e f a u l t
P l e a s e w a i t
w h i l e m a c h i n e
i s r e s t a r t i n g !
Wait until the main screen appears to perform further actions
* R E A D Y *
X R o l l
D r a g K n i f e T o o l
6 0 c m / s
C o p i e s
1
S a v e :
User's Guide SC-PRO Cutting Plotter
CHAPTER 4 : WALKTHROUGH THE OPERATION PANEL
E x i t :
Y 1 1 8 1
1 0 0 g
E x i t :
Set number of copies between 0 and 100
52
AP-75280 – Rev. 1.1
Advertisement
Table of Contents
