Table of Contents
Advertisement
4.2.6
Page mode
The page mode determines the cutter's reaction to a PAGE command sent by the cutting software. The
PAGE command is a command, which is used to relocate the origin after a job is finished and which can take
control remotely of the cutter's automatic sheet-off feature.
intervention, is a feature which is unique to Mutoh cutting-plotters and which enhances the cutter's versatility
and overall performance enormously.
A page-command looks like this: "PG;" or "PGN;" with "n" a number in millimetres.
If the PAGE command "PG;" is sent, the cutter will automatically sheet of regardless of the Page mode,
minimizing the loss of vinyl.
If the PAGE command "PGN;" is sent, the number mentioned after the PG command will be interpreted
differently, depending on the page mode you have chosen:
Page Mode 0 :
The number after the page command is ignored. The media will be cut 5 mm (0.2") after the latest down-
vector. The new cutting limit will be located 0.5 (0.2") from the lower media border.
Page Mode 1 :
The new origin is located "n" millimetres beyond the last down-vector that was sent.
Page Mode 2 :
The new origin is located "n" millimetres beyond the previous origin position.
P a g e M o d e
1
S a v e :
E x i t :
"PGN" is sent (n is a number in mm).
A : Original origin
B : End point last vector
C : New origin with Page Mode 1
D : New origin with Page Mode 2
49
User's Guide SC-PRO Cutting Plotter
CHAPTER 4 : WALKTHROUGH THE OPERATION PANEL
Sheeting-off automatically, without user
AP-75280 – Rev. 1.1
Advertisement
Table of Contents
