Table of Contents
Advertisement
Step 5 :
Position the pressure rollers as you have decided in step 2. Pressure rollers 2-3-4 have a tactile
and audible click system which makes it easier to position them correctly. The right pressure
roller (1) can never be malpositioned.
If one of the others is malpositioned, a message will be displayed after media initialization.
Please refer to the picture.
FRONT of the machine
4
P r e s s u r e r o l l 3
m a l p o s i t i o n e d !
Step 6 :
Set the media load type prior to loading media. Select if you want the cutting plotter to look for the
front edge of the vinyl.
ROLL front
►
ROLL
►
Step 7 :
Load the media properly:
It is best that you hold the front edge of the media
in the middle with one hand and with the other
hand the roll itself.
As you are holding the roll firmly into position, pull
the front edge of the media forward so that there is
an even tension across the whole width of the roll
(= equal tension method)
Do NOT use the rulers to align a roll of media!
They are for use with sheets only. Rolls can only
be correctly installed using the equal tension
method.
The rulers will help you monitoring if the media is
not meandering too much.
3
2
The cutter will measure the left, right and front of the media.
The origin will be defined from the front of the roll.
There will be a shuffle of the set Pre-Feed length.
The cutter will measure the left and right side of the media.
The origin will be defined from the position of the roll when
lowering the lever.
There will be a shuffle of the set Pre-Feed length.
30
User's Guide SC-PRO Cutting Plotter
CHAPTER 3 : BASICS
1
AP-75280 – Rev. 1.1
Advertisement
Table of Contents
