Table of Contents
Advertisement
4.1.6
FORCE key
Please follow the instructions below to change / control the tool force.
Tool force is the amount of downward pressure that the cutter applies on the knife / pen.
We merely want to point out that you have to try to cut your design with the lowest possible pressure that
gives no trouble to weed. Some cast media require only 20 grams to be cut completely through. In that case
there is no need to apply 100 grams of pressure. Too much pressure can cause a decrease of quality.
Be sure that the knife depth has been set correctly. Otherwise, this setting is useless.
Step 1 :
Press the [FORCE] key.
Step 2 :
The current force (in gram) will be displayed. Change the value with the
F o r c e
1 0 0
[ g ]
S t a r t :
Step 3 :
Press the [FORCE] key once again to make a test cut to verify the new force.
Step 4 :
Weed out the pattern
Step 5 :
Check if the top layer is cut completely and that you can see a slight scratch on the backing.
Step 6 :
Press the [ ] key to accept the new value.
T e s t :
User's Guide SC-PRO Cutting Plotter
CHAPTER 4 : WALKTHROUGH THE OPERATION PANEL
40
- keys.
AP-75280 – Rev. 1.1
Advertisement
Table of Contents
