Table of Contents
Advertisement
4.1.7
OFFSET key
Please follow the instructions below to change / control the offset.
Step 1 :
Press the [OFFSET] key.
Step 2 :
The current offset (in mm) will be displayed. Change the value with the
O f f s e t
0 . 5 0
[ m m ]
S t a r t :
Step 3 :
Press the [ ] key to change/test the current value or the [ ] key to abort.
Step 4 :
The following message will be displayed when you have changed the value:
T e s t o f f s e t
T e s t
N o t e s t
Step 5 :
The following pattern will be cut:
Each square will be cut with a different offset.
0,45 0,46 0,47 0,48 0,49 0,50 0,51 0,52 0,53 0,54
Step 6 :
Use the
Step 7 :
Weed out the boxes as and check the patterns and determine which of them gives best quality.
Especially look for good quality of the corners and easy weeding.
Step 8 :
Select one of the offsets with the left-right arrow keys. The EPOS laser will point to the selected
offset / test pattern.
Step 9 :
Press the [ ] key to accept the new offset.
E x i t :
:
o r
:
o r
keys to forward the media.
User's Guide SC-PRO Cutting Plotter
CHAPTER 4 : WALKTHROUGH THE OPERATION PANEL
41
- keys.
AP-75280 – Rev. 1.1
Advertisement
Table of Contents
