Table of Contents
Advertisement
Step 8 :
Be sure that the media is cut off straight at the front to avoid media initialization mismatches.
Notes
Before lowering the pressure rollers, be sure that there is a knife or pen installed in the head. This because
during the media initialization, the penhead will also be initialized. If you insert a pen/knife afterwards, the
machine will not know how to wind the coil of the penhead. This could result in cutting lines across the
complete print.
Step 9 :
Pull the lever down. This action will initialize the media loading sequence, during which the cutter
will shuffle a pre-set distance of vinyl (Pre-Feed Length). The following messages can be
displayed:
R o l l f r o n t
P l e a s e w a i t
Notes
The head will move fast over the media. Be careful not to pinch your fingers during this action.
Please refer to "chapter 4 - Pre-feed Length" to understand the important function of this feature.
Step 10 : After a successful measurement, the main screen will appear. The width of the media will be
displayed:
* R E A D Y *
X R o l l
D r a g K n i f e T o o l
6 0 c m / s
Step 11 : The SC-Pro is ready to receive data from the host computer or Mutoh CutServer.
Y 5 0 0
1 0 0 g
User's Guide SC-PRO Cutting Plotter
R o l l
P l e a s e w a i t
31
CHAPTER 3 : BASICS
AP-75280 – Rev. 1.1
Advertisement
Table of Contents
