Table of Contents
Advertisement
Step 5 :
Make sure that about half of the sheet hangs in front of the machine and half hangs at the back.
This will make it easier to align the media correctly.
Step 6 :
Load the media straight. To help you, two rulers are attached to the front platen.
Step 7 :
Be sure that the media is cut off straight at the front to avoid media initialization mismatches.
Step 8 :
Be sure that the set maximum sheet length is smaller than the actual length of the loaded sheet.
If not, the cutter will automatically swap from sheet to roll front mode.
M a x S h e e t L e n g t h
2 0 0 0
[ m m ]
S a v e :
Notes
Before lowering the pressure rollers, be sure that there is a knife or pen installed in the head. This because
during the media initialization, the penhead will also be initialized. If you insert a pen/knife afterwards, the
machine will not know how to wind the coil of the penhead. This could result in cutting lines across the
complete print.
Step 9 :
Lower the lever.
Notes
the head will move fastly over the media. Be careful not to pinch your fingers during this action.
Step 10 : The cutter will measure the paper. The following message will be displayed:
P l e a s e w a i t
Notes
Please refer to "chapter 4 - Pre-feed Length" to understand the important function of this feature.
Step 11 : When no problems occur, the main screen will appear. The measured width of the media will be
displayed:
* R E A D Y *
X 9 5 0
D r a g K n i f e T o o l
6 0 c m / s
Step 12 : You are ready to cut.
E x i t :
S h e e t
Y 5 0 0
1 0 0 g
User's Guide SC-PRO Cutting Plotter
X = Media length in mm
Y = Media width in mm
33
CHAPTER 3 : BASICS
AP-75280 – Rev. 1.1
Advertisement
Table of Contents
