Table of Contents
Advertisement
4.2.7
Origin
Change / control the default origin after a media load sequence.
Notes
Please make sure media is loaded. If this is not the case, the SC-Pro positioning calculation is based on
previously installed media.
O r i g i n
L R I G H T
S a v e :
Origin
L RIGHT
CENTER
U RIGHT
U LEFT
L LEFT
4.2.8
Laser speed
It is possible to perform a test contour cutting with the SC-Pro cutting plotter. Contour lines will be indicated
by the EPOS laser beam. In case the speed of the test contour cutting is not acceptable, you can decrease
or increase the speed.
2 – 15 – 100 [cm/s]
Laser Speed
Notes
The laser speed has nothing to do with the speed of measuring a frame.
E x i t :
The origin will be set in the lower right corner.
The origin will be set in the centre.
The origin will be set in the upper right corner.
The origin will be set in the upper left corner.
The origin will be set in the lower left corner.
L a s e r S p e e d
1 5
[ c m / s ]
S a v e :
User's Guide SC-PRO Cutting Plotter
CHAPTER 4 : WALKTHROUGH THE OPERATION PANEL
U LEFT
L LEFT
MediaWidth
E x i t :
Laser speed can be set between 2 and 100 cm / s
50
REAR
U RIGHT
CENTER
L RIGHT
FRONT
AP-75280 – Rev. 1.1
Advertisement
Table of Contents
