Table of Contents
Advertisement
5.4.3
EPOS calibration
This test will fine-tune the position of the cutting knife compared to the EPOS laser firmware wisely. This test
can be done manually and automatically. It is recommended however, to let the SC-Pro adjust the values
automatically.
Step 1 :
Install and set a knife.
Step 2 :
Install a dark (black) vinyl. Check with the EPOS readout function if it is dark enough as
described in the previous chapter.
Step 3 :
Press the [TEST]-key.
Step 4 :
Select "EPOS calibration" with the
T e s t
E P O S c a l i b r a t e
M E T H O D : < T E S T >
T o s t a r t :
Step 5 :
Press the [TEST]-key once again to decide whether to perform the test automatically or manually.
E P O S c a l i b r a t e
M a n u a l
3 0 c m / s
T o s t a r t :
Step 6 :
Move the cutter head with the arrow keys to the centre of the media and feed it a bit to be sure
you have enough space (10 cm x 10 cm) for the test.
Step 7 :
Press the [ ] key to start the calibration.
MANUAL CALIBRATION
►
Be sure that you have set an origin.
o
Following pattern will be cut:
o
- keys.
1 2 0 g
70
User's Guide SC-PRO Cutting Plotter
CHAPTER 4 : WALKTHROUGH THE OPERATION PANEL
AP-75280 – Rev. 1.1
Advertisement
Table of Contents
