Table of Contents
Advertisement
5.4 EPOS TEST CUTS
To be able to contour cut, an Epos® feature has been incorporated. This feature will search for the
Reference box and measure the position of the design(s).
When you establish some miscalculations during contour cutting, it is recommended to perform the test cuts
described below.
After these test, everything should be all right. If not, please contact an Authorized Mutoh Technician.
5.4.1
EPOS alignment
5.4.1.1
Tools necessary:
SC-Pro.
►
Host Computer with the Mutoh CutServer installed on.
►
EPOS final check chart pre-printed on vinyl or paper.
►
Drag knife when testing on vinyl.
►
Pressurized ballpoint pen when testing on paper.
►
5.4.1.2
Alignment procedure
Step 1 :
Load the appropriate tool (a knife on vinyl and a pen on
paper).
Step 2 :
Power ON the cutter and be sure that the lever is raised.
Step 3 :
Press the [TOOL] button and set the tool you are using.
Step 4 :
Set the media type to "Sheet".
Step 5 :
Insert the test sheet as described in the chapter "Loading sheet media" with the arrow in the top
right corner and the outer pressure rollers outside the reference box. The middle pressure rollers
may be disabled.
Step 6 :
Pull the lever down.
Step 7 :
Set your speed and force values accordingly.
Step 8 :
Make sure there is a connection between the Mutoh CutServer and the cutter by selecting the
checkbox near to the requested cutter.
T o o l
P e n
S t a r t :
E x i t :
User's Guide SC-PRO Cutting Plotter
CHAPTER 4 : WALKTHROUGH THE OPERATION PANEL
T o o l
K n i f e
S t a r t :
67
325 mm
E x i t :
AP-75280 – Rev. 1.1
445 mm
Advertisement
Table of Contents
