Table of Contents
Advertisement
4.3.4
Updating the keyboard
After installation of a new cutter firmware, it is highly recommended to update the keyboard firmware as
described below:
Step 1 :
Power ON the cutter.
Step 2 :
Install the new firmware.
Step 3 :
Press the special key combination to start the installation.
Step 4 :
Confirm that you want to update the keyboard firmware.
K e y b o a r d ?
Y e s :
N o
:
Step 5 :
The following message will be displayed:
K e y b o a r d u p d a t e !
P l e a s e w a i t . . .
D O N O T S H U T D O W N !
The installation will take approximately 1 minute.
Step 6 :
After installation, a beep will sound and the main screen will be displayed again.
4.3.5
Reset the keyboard
It might be possible that the keyboard does not correspond anymore. To avoid to reboot the cutter; a special
key combination is made available to reset the keyboard.
Step 1 :
Press the special key combination to start the installation.
Step 2 :
The keyboard will reset and the main screen will be displayed again.
Step 3 :
If the keyboard does not respond still, you have to reboot the cutter.
+
+
U p d a t e
o r
o r
+
+
User's Guide SC-PRO Cutting Plotter
CHAPTER 4 : WALKTHROUGH THE OPERATION PANEL
+
+
60
AP-75280 – Rev. 1.1
Advertisement
Table of Contents
