Table of Contents
Advertisement
TO ADJUST THE KNIFE DEPTH, PROCEED AS FOLLOWS:
STANDARD KNIFE HOLDER
Hold the body (2) in one hand and adjust the
depth by using the set screw (3).
STANDARD KNIFE HOLDER
Turning the set screw (3) clockwise will make the
blade protrude out of the edge of the base part
(1). Turning the set screw (3) counter clockwise,
will retract the blade.
For a first test, turn out the blade until it protrudes
about 0.2mm (0.008") out of the base part
Make a manual test-cut on a small piece of media, of the same type that you will be using. Adjust the depth
until the top layer is cut completely and that you can see a slight scratch on the backing when peeling off.
At no times you should be able to see a scratch at the back side of the media.
Repeat steps 2 and 3 until the correct depth is obtained.
User's Guide SC-PRO Cutting Plotter
CHAPTER 4 : WALKTHROUGH THE OPERATION PANEL
OPTIONAL KNIFE HOLDER WITH NONIUS
Loosen the base part of the cutting knife. To do this,
take the base part in your left hand and twist the ring
slightly.
OPTIONAL KNIFE HOLDER WITH NONIUS
Take the base part and the ring in your left hand and
twist the shaft until the knife point protrudes about 0.2
mm (0.008") out of the edge of the base part.
Tighten the ring firmly against the base part. This will
prevent the cutting blade from coming loose during
cutting.
64
AP-75280 – Rev. 1.1
Advertisement
Table of Contents
