Table of Contents
Advertisement
4.2.17
Program step
Please note that some software packages use the "step per mm" terminology, in which case a program step
of 0.025 mm corresponds with 40 steps per mm and a program step of 0.010 mm with 100 steps per mm.
Contour cutting supports only 0.010 mm program step.
Notes
If the plot unit is not set correctly, all your cutting jobs will be cut 2.5 times too large or too small.
Program Step
4.2.18
VS/ZF/AS
Several cutting software packages enable the user to send speed, force and acceleration commands to the
cutter. The cutter can be set up to ACCEPT or IGNORE these commands.
Notes
When VS and ZF commands are sent and accepted, they will override the speed, force and acceleration
settings the user may have set from the cutter operation panel.
When the VS and ZF commands are ignored, the cutter will always use the settings, which are set-up from
the cutter operation panel.
4.2.19
LCD contrast
Change the LCD contrast as you wish.
LCD contrast
0 – 16 – 32
P r o g r a m s t e p
0 . 0 1 0
[ m m ]
S a v e :
E x i t :
0,010mm
Set the step to 0.010 mm
0,025mm
Set the step to 0.025 mm
V S / Z F / A S
A C C E P T
S a v e :
E x i t :
VS / ZF / AS
ACCEPT
IGNORE
L C D c o n t r a s t
1 6
S a v e :
E x i t :
Set LCD contrast between 0 and 32
0 = bright
32 = dark
54
User's Guide SC-PRO Cutting Plotter
CHAPTER 4 : WALKTHROUGH THE OPERATION PANEL
AP-75280 – Rev. 1.1
Advertisement
Table of Contents
